If you do not have an Axon Dock, you can upload video with a Windows compatible computer using Evidence Sync.
Camera Upload to Evidence.com and Charging using an Axon Dock
- Make sure the Dock is powered on and connected to the internet.
- Turn the controller off.
- Disconnect the camera cable from the controller and camera.
- Dock the camera and controller into the appropriate bay in the Axon Dock. (Initial connection will show a momentary red LED on the camera.)
When you plug your camera and controller into the Axon Dock, the camera and controller status LEDs display the device status.
Device Status Status LED Indicator Initial connection (momentary) Solid red In queue awaiting upload Solid yellow Device ready (all videos uploaded successfully) Solid green Device not assigned, agency mismatch, or camera set in the offline mode Blinking red Uploading data Blinking yellow Firmware update, extremely low battery, or memory full Blinking red and yellow DO NOT remove the camera from the Dock
Transfer error, device if re-trying to transfer Blinking green and yellow Possible network error. Refer to the Troubleshooting chapter of the User Manual. Blinking red, yellow, and then green (cycling all colors) Dock has no communication with camera LED off Note: If an Axon setting (e.g., orientation, audio, video setting) has changed in Evidence.com, it will be updated while the camera is in the Dock.
Battery Status while in an Axon Dock
The controller’s battery LED displays the battery’s capacity when the device is being used or when charging.
Battery Status | Battery LED |
---|---|
Battery capacity is at 40–100 percent | Green |
Battery capacity is 20–39 percent | Yellow |
Battery capacity is less than 20 percent | Red |