If you do not have an Axon Dock, you can upload video and charge your camera with a Windows compatible computer using Evidence Sync.
Camera Upload to Evidence.com Using the Dock
- Make sure the Dock is powered on and connected to the internet.
- Turn your body camera off.
- Dock the camera into a bay in the Axon Dock. (Initial connection will show a momentary red LED on the camera.)
Note: If an Axon setting (e.g., orientation, audio, video setting) has changed in Evidence.com this will be updated while the camera is in the Dock.
When you plug an Axon Body 2 camera into the Axon Dock, the camera status LED displays the device status.
Device Status | Status LED Indicator |
---|---|
Initial connection (momentary) | Solid red (for 20 seconds or less) |
In queue awaiting upload | Solid yellow |
Device ready (all videos uploaded successfully) | Solid green |
Device not assigned, agency mismatch, or camera set in the offline mode | Blinking red |
Uploading data | Blinking yellow |
Firmware update, extremely low battery, or memory full | Blinking red and yellow
DO NOT remove the camera from the Dock |
Transfer error, device if re-trying to transfer | Blinking green and yellow |
Possible network error. Verify the Axon Dock is registered and refer to the Axon Body 2 Camera Troubleshooting section or Axon Dock Troubleshooting section | Blinking red, yellow, and then green (cycling all colors) |
Axon Dock has no communication with the camera. Verify the Axon Dock core and bays are seated properly. Contact Axon Technical Support if not resolved. | LED off |
Battery Status while in an Axon Dock
When the camera is in the Axon Dock, the camera battery LED displays the battery’s capacity when charging.
Battery Capacity | Battery LED while in Axon Dock |
---|---|
Fully charged (capacity greater than 98%) | Green |
Charging in progress (capacity 20% - 98%) | Yellow |
Charging in progress (capacity less than 20%) | Red |