Battery Charging Information
When an Axon Body 2 camera or Axon Flex 2 Controller is placed in a bay, the device will begin to charge. The color of the Battery LED around the EVENT button indicates the battery’s status.
Axon Fleet cameras do not charge in the Axon Dock and the Battery LED displays solid green.
| Battery Capacity | Battery LED while in Axon Dock |
|---|---|
| Fully charged (capacity greater than 98%) | Green |
| Charging in progress (capacity 20% - 98%) | Yellow |
| Charging in progress (capacity less than 20%) | Red |
Camera/Controller LED Information
When you plug an Axon camera or controller into the Axon Dock, the camera/controller status LED displays the device status.
See the camera’s user manual for more information about the camera and its LEDs.
| Device Status | Camera LED |
|---|---|
| Initial connection (momentary) | Solid red (for 20 seconds or less) |
| In queue awaiting upload | Solid yellow |
| Device ready (all videos uploaded successfully) | Solid green |
| Device not assigned, agency mismatch, camera set in the offline mode, or device error | Blinking red |
| Uploading data |
Blinking yellow |
| Firmware update, internal battery charging, extremely low battery, or memory full |
Blinking red and yellow DO NOT remove the camera from the Axon Dock |
| Transfer error, device re-trying to transfer | Blinking green and yellow |
| Possible network error. Verify the Axon Dock is registered and refer to the appropriate Axon camera Troubleshooting section or Axon Dock Troubleshooting section. | Blinking red, yellow, then green (cycling all colors) |
| Axon Dock has no communication with the camera. Verify the Axon Dock core and bays are seated properly. Contact Axon Technical Support if not resolved. | LED off |