Loading the TASER 7 Cartridges
TASER 7 Cartridges are shipped with a safety clip in place. Remove these covers before attempting to load a cartridge into a TASER 7 CEW. See Remove the Cartridges from the Safety Clip for more information.
Always treat your TASER 7 CEW as if it were loaded.
Unloaded TASER 7 CEW viewed at an angle:
Loaded TASER 7 CEW viewed at an angle:
1. Point the CEW in a safe direction.
2. Ensure the safety switch is in the down (SAFE) position and your finger is not on the trigger or Arc switch.
3. Ensure the protective safety clip is removed from the TASER 7 Cartridge.
4. Keeping your hand away from the blast doors, gently push the TASER 7 Cartridge into the cartridge bay until an audible click is heard.
Note the orientation of the cartridge; the portion of the cartridge that has writing on it is the top of the cartridge. The top of the cartridge must face the upper part of the cartridge bay. (This is a top view of the cartridge.)
5. Verify that the cartridge is secure by pulling on the sides of the cartridge.
Cartridge Release Button
TASER 7 Cartridges are held in the TASER 7 CEW after they are loaded. Press the cartridge release button to release the cartridges before attempting to remove them from the CEW. For further instructions, see Unloading.
Unloading
1. Point the CEW in a safe direction.
2. Ensure the safety switch is in the down (SAFE) position.
3. Keep your hands away from the front of the cartridges.
4. With your thumb, press the release button.
5. Firmly pull the cartridges out of the bay by pulling on the sides of the cartridges.